DCS Training Course

What Will You Learn?

• Training session-1
• 1.1 Project creation
• 1.2 ASSIGINING OF FCS
• 1.3 Node creation
•  1.4 Input & output module creation
•  1.5Labelling of IOM
• Training session -02
• 2.1 Function block introduction
• 2.2 Drawing page nomination
• 2.3 Programming for Open loop creation
• 2.4 Programming for Close loop creation
• Training session-03
• 3.1 Programming for Cascade loop creation
• Training session -04
• 4.1Programming for creation of new close loop
• 4.2 Operation of new close loop on HMI
• Training session -05
• 5.1 Learning operation of cascade loop HMI
• Training session -06
• 6.1 Concept of FOUT loop
• 6.2 Difference between FOUT loop & Cascade loop
• 6.3Programming with FOUT loop
• 6.4Grouping of FACEPLATE
• 6.5Operation of FOUT on HMI
• Training session -07
• 7.1Control signal splitter (SPLIT)
• 7.2Operation of SPLIT
• 7.3Switch setting in SPLIT
• Training session -08
• 8.1 Logic creation with auto selector
• 8.2 Operation of auto selector on HMI
• Training session-09
• 9.1Logic creation with signal selector
• 9.2 Operation of logic created by signal selector
• Training session -10
• 10.1 Concept of arithmetic block
• In that we will do programming for
• Addition
• Divide
• Subtract
• 10.2 Average
• Training session-11
• 11.1 Velocity limiter block (VELLM)
• Training session-12
• 12.1 Concept of Calcu (Calculation) block
• 12.2 Programming with Calcu block (AND, OR logic creation)
• Training session-13
• 13.1 Concept of ST16
• 13.2 Programming for AND logic by ST16
• 13.3 Programming for two valve operation on Alarm status
• 13.4 Programming for Auto-Manual changeover over of PID based on condition change
• Training session-14
• 14.1Programming for Motor control block
• 14.2 Operation of motor control block on HMI
• Training session -15
• 15.1 Logic creation by LC64
• 15.2 Operation of LC-64 Block on HMI
• Training session-16
• 16.1Concept of trend
• 16.2 Trend setting