About Course
A PRACTICAL TRAINING COURSE ON DCS
What do you get with this?
Lifetime access +Training certificate+ Member of the biggest community (+10k member)of control &instrumentation + regular job updates & Interview Guidance( members got job and many pramoted in their job)+ Abroad job guidance
What Will You Learn?
- Training session-1
- 1.1 Project creation
- 1.2 ASSIGINING OF FCS
- 1.3 Node creation
- 1.4 Input & output module creation
- 1.5Labelling of IOM
- Training session -02
- 2.1 Function block introduction
- 2.2 Drawing page nomination
- 2.3 Programming for Open loop creation
- 2.4 Programming for Close loop creation
- Training session-03
- 3.1 Programming for Cascade loop creation
- Training session -04
- 4.1Programming for creation of new close loop
- 4.2 Operation of new close loop on HMI
- Training session -05
- 5.1 Learning operation of cascade loop HMI
- Training session -06
- 6.1 Concept of FOUT loop
- 6.2 Difference between FOUT loop & Cascade loop
- 6.3Programming with FOUT loop
- 6.4Grouping of FACEPLATE
- 6.5Operation of FOUT on HMI
- Training session -07
- 7.1Control signal splitter (SPLIT)
- 7.2Operation of SPLIT
- 7.3Switch setting in SPLIT
- Training session -08
- 8.1 Logic creation with auto selector
- 8.2 Operation of auto selector on HMI
- Training session-09
- 9.1Logic creation with signal selector
- 9.2 Operation of logic created by signal selector
- Training session -10
- 10.1 Concept of arithmetic block
- In that we will do programming for
- Addition
- Divide
- Subtract
- 10.2 Average
- Training session-11
- 11.1 Velocity limiter block (VELLM)
- Training session-12
- 12.1 Concept of Calcu (Calculation) block
- 12.2 Programming with Calcu block (AND, OR logic creation)
- Training session-13
- 13.1 Concept of ST16
- 13.2 Programming for AND logic by ST16
- 13.3 Programming for two valve operation on Alarm status
- 13.4 Programming for Auto-Manual changeover over of PID based on condition change
- Training session-14
- 14.1Programming for Motor control block
- 14.2 Operation of motor control block on HMI
- Training session -15
- 15.1 Logic creation by LC64
- 15.2 Operation of LC-64 Block on HMI
- Training session-16
- 16.1Concept of trend
- 16.2 Trend setting
There are no reviews yet.